

Home | SLS | Materials | Request a Quotation | Case Studies | Contact



DuraForm PA is based on nylon 12 and provides excellent mechanical properties for parts used in functional testing. In many cases low volumes of end-use parts can be manufactured offering long term stability with good chemical resistance and low moisture absorption. Parts can also be sterilised using autoclaving and comply to USP Class VI testing. DuraForm PA is easily processed delivering consistently good surface resolution and feature detail. The choice material where functionality is the key requirement.
General Properties | Value | Test |
Specific Density | 1.0 g/cm3 | ASTM D792 |
Moisture Absorption – 24 hours | 0.07% | ASTM D570 |
Mechanical Properties | Value | Test |
Tensile Strength, Yield | N/A | ASTM D638 |
Tensile Strength, Ultimate | 43 MPa 6237 psi) | ASTM D638 |
Tensile Modulus | 1586 MPa (230 ksi) | ASTM D638 |
Elongation at Yield | N/A | ASTM D638 |
Elongation at Break | 14% | ASTM D638 |
Flexural Strength, Yield | N/A | ASTM D790 |
Flexural Strength, Ultimate | 48 MPa (6962 psi) | ASTM D790 |
Flexural Modulus | 1387 MPa (201 ksi) | ASTM D790 |
Hardness, Shore D | 73 | ASTM D2240 |
Impact Strength (notched IZOD, 23°C) | 32 J/m (0.6 ft-lb/in) | ASTM D256 |
Impact Strength (unnotched IZOD, 23°C) | 336 J/m (6.3 ft-lb/in) | ASTM D256 |
Garner Impact | 2.7 J (2.0 ft-lb) | ASTM D5420 |
Thermal Properties | Value | Test |
Heat Deflection Temperature (HDT) | 180°C (356°F) @ 0.45 MPa | ASTM648 |
Coefficient of Thermal Expansion (51-150°C) | 62.3 µm/m-°C (34.6 µin/in-°F) @ 0-50°C | ASTM E831 |
Specific Heat Capacity | 1.64 J/g-°C (0.392 BTU/lb-°F) | ASTM E1269 |
Thermal Conductivity | 0.7 W/m-K (4.86 BTU-in/hr-ft2-°F | ASTM E1225 |
Flammability | HB | UL 94 |
Electrical Properties | Value | Test |
Volume Resistivity | 5.9 x1013 ohm-cm | ASTM D257 |
Surface Resistivity | 7.0 x1013 ohm | ASTM D257 |
Dissipation Factor, 1 KHz | 0.044 | ASTM D150 |
Dielectric Constant, 1 KHz | 2.73 | ASTM D150 |
Dielectric Strength | 17.3 kV/mm (439 kV/in) | ASTM D149 |
Data was generated by building parts under typical default parameters. |
|
|
Copyright © 2022 Keyworth Rapid Manufacturing Limited | Privacy+Cookies |Terms & Conditions